Tearaway Washaway Embroidery Stabilizer Directions:

1. Hoop one layer of the embroidery stabilizer with your garment or fabric.
   
2. Make sure that your embroidery stabilizer is at least one inch larger on all sides than your hoop.
   
3. This makes it much easier to handle and to hoop tightly.
   
4. What you want to achieve in your hoop is a tambourine-skin type tension
   
5. Embroider your design. If the design is dense or more than the suggested number of stitches, you can float another layer of this or another tearaway under your hoop. Or with your initial hooping, you can use two layers of the Washaway Tearaway.
   
6. . Remove your garment and lightly moisten with a controlled amount of water - a moist rag or sponge will do. Do NOT use a lot of water.
   
7. Tear away as much of the embroidery stabilizer as possible.
   
8. The embroidery stabilizer remnants between lettering or open parts of your design will dissipate and disappear after the initial wash.

Tearaway - Washaway Embroidery Stabilizer is available in 1.5oz, 2oz and 2.5oz Rolls and Pre-Cuts:

Click here to purchase 1.5oz roll
Click here to purchase 2oz roll
Click here to purchase 2.5oz roll

Click here to purchase 1.5oz pre-cuts
Click here to purchase 2oz pre-cuts
Click here to purchase 2.5oz pre-cuts