Fuse & Tear Embroidery Stabilizer is a fusible tear-away embroidery stabilizer with a low melt fusible coating

embroidery stabilizersembroidery stabilizers
embroidery stabilizers
embroidery stabilizers
Home Page Policies Store Front Contact Us
    Purchase This Embroidery Stabilizer
(more purchase options below)

Fuse & Tear® Embroidery Stabilizer Directions:

  1. Fuse one layer of Fuse and Tear® to the back of the fabric to be embroidered before hooping. Be sure to use a piece slightly larger than the hoop to insure proper hooping tension *Important - Use a low to medium temp 260 degrees F - silk setting on your iron. A press cloth underneath your iron is recommended.
  2. Hoop the garment and embroidery stabilizer. Try to achieve or approach a “tambourine skin” type tension in your hoop.
  3. Embroider your design. If the design is dense or more than the suggested number of stitches float another layer of tearaway under the hoop and the first tearaway layer for extra support.
  4. Once the design is complete tearaway the excess embroidery stabilizer.

Fuse & Tear Embroidery stabilizer is available in several roll sizes
Click here to purchase Fuse & Tear by the roll

Fuse & Tear Embroidery stabilizer is available in 8" x 8" white pre cuts
Click here to purchase Fuse & Tear pre cuts

 

Fuse & Tear Embroidery Stabilizer is a fusible tear-away embroidery stabilizer with a low melt fusible coating